Feb 8, 2011

I Finally Figured it Out!

After lots of different attempts with lots of different substances I finally have figured out how to make molds so that I can make my own architectural appliqués.

After trying polymer clay, different types of rubber, and after learning what a "Mother Mold" is and how to make it, I finally understand how to make these molds. This will allow me to make lots of gorgeous architectural appliqués that can be used for tons of different decor projects.

Below are some of the molds I have made with Mold Builder. This is a liquid rubber that is brushed on in layers. It works well, however you need to make a Mother Mold with plaster (inexpensive and easy to use) so that your mold has a base that supports it. Without this Mother Mold the liquid resin would spill out of the mold. You can see the Mother Molds in the pictures below - they are the white plaster bases under each mold. This top mold is my favorite. It is a large floral bouquet mold and it is gorgeous! It is a mold of the appliqué that I used on the antique trunk that is listed in my store (http://www.etsy.com/listing/56033466/antique-handpainted-trunk).



Mold Builder is good for the larger molds because you don't have to use as much so it is more cost effective.You can also use it on surfaces that are vertical. However the best product that I found to make molds with is Oomoo 30 which is a pourable silicone rubber. You put whatever you are making a mold of in the bottom of a container and pour the Oomoo over it and wait for it to cure. These molds don't need a Mother Mold and they are very strong and flexible so you can easily peel the cast resin out of them. Below are pictures of some of the molds I have made from Oomoo 30.

                                       



I made the cameo molds above from two framed cameos I have in my living room. Below is one of these framed cameos. I love these and can't wait to make similar framed cameos for my shop on Etsy - Lula Belle.

Below are some of the resin casts that I made from these molds. The resin is not dyed so they are clear. I got some opaque pigment to add to the resin so I can now make these but they will be white in color. This makes it easier to see the detail and also makes them easier to paint. 






Below are the two cameos that I made molds for and these are made with plaster.


I am constantly looking for things I can mold and thinking of projects I can use them for. I get so excited to have figured this out and am looking forward to seeing what I can do with these molds and architectural pieces I can now make. The possibilities are endless!

Thanks for visiting and come back for more...


                                                                                 Kate

2 comments:

  1. What is the name of the resin that you use? I am so thankful that Ihave found your site. I have been trying to make my own appliques , but was failing..

    ReplyDelete
  2. I am so excited to give all of this a try...I, too, would like to know the name of the Resin you use and also the opaque pigment so the appliques you make will be white. Also, where do you find the Oomoo 30.I have used mold builder before but not to make a casting. Do you just keep painting on layers until the mold is thick enough so you have a casting? Thanks so much. My email is cecedreams@gmail.com

    ReplyDelete

Share your thoughts, comments, suggestions here!
Thank you,
Kate

There was an error in this gadget